Your brush images or textures should appear after restart of the software. Of certain file dimensions or size : The max maybe 1024 x 1024 and below. In the picture below, the orange has been cloned to appear as part of the apple.This is basic advice that was given me in a email. In this respect, Hardness can be considered the strength of the antialiasing used to soften edges.īecause of the relationship between Hardness and Antialiasing the Hardness setting is ignored if Antialiasing is disabled.Ī low Hardness value can be used to make stamped regions less obvious.Ī Blend Mode can also be applied, much like a layer blend only specific to the tool path. See Blend Modes for more information. Reducing the Hardness setting has the effect of softening the edge of the stamp.
To break the link, set a new source point by holding down the Ctrl key and clicking at a different location.Ĭlone Stamp inherits the Brush Width, Hardness and Antialiasing settings from the Tool Bar. This relationship will persist through tool changes and other editing operations. Once the relationship is set, the points remain locked together.Ĭlone source and destination are locked together once cloning starts. The relationship between the source and destination is fixed once the actual cloning is started.
Note that the source point moves in the same path as the tool when cloning starts. This results in the tool path being copied as a stripe rather than just the source point. Click and drag to copy from the source to the destination. Navigate to the destination location (where you want the pixels to be copied to). The source location will remain where it was set. Repeating Ctrl + Click sequence resets the source to the newly clicked location. Set the source point by holding down the Ctrl key and clicking on the source image.
0 kommentar(er)
